Foreman 500 won’t move possible clutch issue

[Mod_my_ATV]

I swapped out the rear output seal on my 2006 Foreman 500, and now it shifts fine, but it won't move when I give it gas. It feels like the clutch isn't catching. It was working fine before I did the seal. Any ideas on what's up?

 

[HondA11y]

When you pulled the swingarm to get at the seal, did you unhook the shift linkage or just let it hang?
You're not the first one I've heard who encountered this issue and it's mostly because they forget about the shift linkage when they're messing with the rear end.
Your case sounds like it's a bit out of whack and not letting the clutch fully engage.
I suggest you try adjusting it a little at a time and see if that fixes it.
Also double-check that you got the clutch cover seated right and didn't pinch the gasket or anything when you put it back on.
Let me know if this helps. Good luck!